Developing Section; Detaching And Refitting The Developing Unit - Kyocera Mita KM-4530 Service Manual

2BC/D

1-6-6 Developing section

(1) Detaching and refitting the developing unit

Follow the procedure below to check, clean or replace the developing unit.
Procedure
1. Open the front cover.
2. Remove the screw holding the image
formation left cover and then the cover.
3. Remove the three screws and disconnect the
connector, tilt the paper conveying unit
release lever down, and then pull out the
image formation unit.
4. Remove the two screws and open the image
formation rail in the direction of the arrow.
1-6-44
Image formation left cover
Figure 1-6-78
Connector
Image formation unit
Paper conveying release lever
Figure 1-6-79
Image formation rail
Figure 1-6-80