Kyocera Mita KM-4530 Service Manual page 230

2BC/D
17. Loosen the two screws securing the mirror 2
frame.
18. Insert the mirror 1 lower frame into the
scanner unit and seat it on the positioning
holes.
19. Insert the two frame securing tools into the
positioning holes in the front and rear of the
scanner unit and determine the positions of
the mirror 1 lower frame and mirror 2 frame.
20. While holding the scanner wire on the mirror
1 lower frame, secure the wire retainers at the
front and rear of the mirror 1 lower frame
using the two screws for each.
21. Retighten the two screws securing the mirror
2 frame.
22. Remove the two screws holding each of the
two frame securing tools and then the tools.
23. Refit all the removed parts.
1-6-26
Frame securing tool
Wire retainer
Mirror 1 lower frame
Frame securing tool
Mirror 2 frame
Figure 1-6-49
Mirror 2 frame
Wire retainer
Mirror 1
lower frame