Kyocera Mita KM-4530 Service Manual page 149

2BC/D
Section Jam code
Feedshift 52
section
53
Duplex 60
section
61
62
63
64
65
66
67
68
DF 70
71
1-5-6
Description
Misfeed in feedshift sec-
tion
Misfeed in feedshift de-
tention section
Misfeed in duplex tray
section
Misfeed in duplex
feedshift section (face
down eject)
Misfeed in duplex
feedshift section (duplex)
Misfeed in duplex paper
conveying section 1
Misfeed in duplex paper
conveying detention sec-
tion 1
Misfeed in duplex paper
conveying section 2
Misfeed in duplex paper
conveying detention sec-
tion 2
Misfeed in duplex eject
section
Misfeed in duplex eject
detention section
No original feed
An original jam in the
original feed section 1
Conditions
The feedshift switch (FSSW) does not turn on within 1190
ms of the eject switch (ESW) turning on.
The feedshift switch (FSSW) does not turn off within 1190
ms of the eject switch (ESW) turning off.
Even if 1190 ms elapses after the eject switch (ESW) turns
on, the OFF status of the feedshift switch (FSSW) for the
preceding paper is not detected.
The duplex feedshift switch (DUPFSSW) does not turn on
within 860 ms of the duplex reversing clutch (DUPREVCL)
turning on.
The face down eject switch (FDESW) does not turn on within
1120 ms of the duplex feedshift switch (DUPFSSW) turning
on.
Duplex paper conveying switch 1 (DUPPCSW1) does not
turn on within 910 ms of the duplex feedshift switch
(DUPFSSW) turning on.
Even if 860 ms elapses after the duplex reverse clutch
(DUPREVCL) turns on, the ON status of the duplex feedshift
switch (DUPFSSW) for the preceding paper is not detected.
Duplex paper conveying switch 2 (DUPPCSW2) does not
turn on within 1280 ms of duplex paper conveying switch 1
(DUPPCSW1) turning on.
Duplex paper conveying switch 2 (DUPPCSW2) does not
turn off within 1280 ms of duplex paper conveying switch 1
(DUPPCSW1) turning off.
Duplex paper conveying switch 2 (DUPPCSW2) does not
turn off within 1280 ms of duplex paper conveying switch 1
(DUPPCSW1) turning on.
The duplex eject switch (DUPESW) does not turn on within
1270 ms of duplex paper conveying switch 2 (DUPPCSW2)
turning on.
The duplex eject switch (DUPESW) does not turn off within
1270 ms of duplex paper conveying switch 2 (DUPPCSW2)
turning off.
The duplex eject switch (DUPESW) does not turn off within
1270 ms of duplex paper conveying switch 2 (DUPPCSW2)
turning on.
Paper feed switch 1 (PFSW1) does not turn on within 1200
ms of the duplex eject switch (DUPESW) turning on.
Paper feed switch 1 (PFSW1) does not turn off within 1200
ms of the duplex eject switch (DUPESW) turning off.
In the primary original feed for the second original or after in
the 1 sided or 2 sided original mode, even if retry operation is
performed two times, primary original feed is not performed.
In the secondary original feed in the 1 sided original mode,
even if the specified number of pulses of the original feed
motor (OFM) passes after the original switchback switch
(OSBSW) turns on, the ON status of the DF timing switch
(DFTSW) is not detected.