Detaching And Refitting The Registration Cleaner Brush; Detaching And Refitting The Lower Registration Cleaner - Kyocera Mita KM-4530 Service Manual

(3) Detaching and refitting the registration cleaner brush

Follow the procedure below to clean or replace the registration cleaner brush.
Procedure
1. Remove the developing unit (see page 1-6-
44).
2. Remove the two screws and then remove the
registration cleaner brush.
3. Replace the registration cleaner brush and
refit all the removed parts.

(4) Detaching and refitting the lower registration cleaner

Follow the procedure below to clean or replace the lower registration cleaner.
Procedure
1. Open the front cover, tilt the paper conveying
unit release lever down, and pull out the
paper conveying unit.
2. Remove the screw and pull the lower
registration cleaner toward you to remove it.
3. Replace the lower registration cleaner and
refit all the removed parts.
Registration cleaner brush
Figure 1-6-28
Lower registration
cleaner
Figure 1-6-29
2BC/D
1-6-13