Kyocera Mita KM-4530 Service Manual page 38

2BC/D
Connecting the power cord.
1. Refit the front cover to its original position.
2. Connect the power cord to the connector on the copier.*
* 200-240 V specifications only.
3. Insert the power plug into the wall outlet. and turn on the main switch with the front cover open.
Initializing the developer (run of maintenance mode U130).
1. After warm-up starts and the message "Close the front cover." appears, use the numeric keys to
enter "10871087" to start the maintenance mode.
2. Use the numeric keys to enter "130" and press the Start key.
3. Close the front cover.
4. Press the Start key.
* After approximately two minutes, the toner sensor control voltage and the toner control level will
be automatically set and the preset values will be displayed on the touch panel.
Example of display
INPUT: 130 (toner sensor output voltage)
CONTROL: 125 (toner sensor control voltage)
TARGET: 103 (toner feed start level)
HUMID: 65 (absolute humidity)
5. Press the Stop/clear key.
Applying toner to the cleaning blade (run of maintenance mode U160).
1. Use the numeric keys to enter "160" and press the Start key.
2. Press the Start key.
* The drum will be covered with toner and driving will stop automatically.
Exit maintenance mode.
1. Open and close the front cover, use the numeric keys to enter "001", and press the Start key.
* The machine will exit from the maintenance mode.
Setting the cleaning blade.
1. Open the front cover. Remove the three screws
and the connector that secure the image
formation unit and turn down the paper conveying
unit release lever to pull out the image formation
unit.
2. After checking that the drum is covered with
toner, loosen the blade securing pin on the left
side of the imaging unit, slide the blade release
lever in the direction indicated by the arrow, and
tighten the blade securing pin.
* The cleaning blade will be set so that it touches
the drum.
3. Push the image formation unit into the machine to
set, and raise the paper conveying unit release
lever.
4. Fit the three screws and the connector to secure
the image formation unit.
1-3-10
Blade securing pin
Blade release lever
Figure 1-3-21