Detaching And Refitting The Pulley Of Drawer 4 - Kyocera Mita KM-4530 Service Manual

(1-2) Detaching and refitting the pulley of drawer 4

Procedure
• Removing the forwarding pulley
1. Pull out drawers 3 and 4 and then pull out the
deck conveying unit.
2. Remove the pin, raise the forwarding pulley
retainer in the direction of the arrow, and then
remove it from the deck conveying unit.
3. Remove the stop ring, pull the forwarding
pulley shaft in the direction of the arrow, and
then remove the forwarding pulley.
* When fitting the forwarding pulley, ensure that
the gear section engages.
Deck conveying unit
Figure 1-6-12
Forwarding pulley retainer
Figure 1-6-13
Stop ring
Forwarding pulley
Figure 1-6-14
2BC/D
Pin
Forwarding pulley shaft
1-6-7