Kyocera Mita KM-4530 Service Manual page 34

2BC/D
4. Remove the two screws and open the image
formation rail.
5. Remove the 1P connector from the developing
unit and the 4P connector from the sub toner
hopper. Raise the shutter a little and slide it
toward the front side of the machine.
6. Turn the auxiliary toner hopper to the right of the
machine.
7. Hold the front and the rear of the developing unit
and remove the unit from the image formation
unit.
1-3-6
Figure 1-3-11
1P connector
4P connector
Shutter
Figure 1-3-12
Figure 1-3-13
Image formation rail
Sub toner hopper
Developing unit