Kyocera Mita KM-4530 Service Manual page 102

Maintenance
item No.
U132 Replenishing toner forcibly
Description
Replenishes toner forcibly until the toner sensor output value reaches the toner feed start level.
Purpose
Used when the toner empty is detected frequently.
Method
1. Press the start key. The screen for executing is displayed.
2. Press the start key. Operation starts, and the current data is displayed.
Toner is replenished until the toner sensor output value reaches the toner feed start level.
Display
INPUT
CONTROL
TARGET
HUMID
3. To stop operation, press the stop/clear key.
Completion
Press the stop/clear key when toner replenishment stops. The screen for selecting a maintenance item No. is
displayed.
Checking toner motors operation
U135
Description
Drives the toner motor.
Purpose
To check the operation of the toner motor.
Caution
Note that driving the motor unnecessarily long may cause a toner jam, resulting in machine lockup. Be sure to
drive the motor for only a few seconds.
Method
1. Press the start key. The screen for selecting an item is displayed.
2. Select the item to be operated. The selected item is displayed in reverse. The toner motor turns on.
Display
MOTOR1
MOTOR2
3. To stop operation, press the stop/clear key.
Completion
Press the stop/clear key when operation stops. The screen for selecting a maintenance item No. is displayed.
U136 Turning the toner level detection function on/off
Description
Turning the control based on the toner level sensor output on/off.
Purpose
To enable copying using the toner in the developing section after the toner level in the toner hopper decreases,
by turning the control function off.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select ON or OFF. The selected item is displayed in reverse.
Display
ON
OFF
Initial setting: ON
2. Press the start key. The value is set.
Completion
To exit this maintenance item without changing the current value, press the stop/clear key. The screen for
selecting a maintenance item No. is displayed.
Description
Description
Toner sensor output value after start key is pressed
Current toner feed start level
Current toner sensor control voltage
Absolute humidity
Motor
Toner feed motor (TFM)
Toner agitation motor (TAM)
Description
Controls based on the detection by the toner sensor detection sensor
Ignores the detection by the toner level detection sensor
2BC/D-1
1-4-35