Detaching And Refitting The Scanner Wires; Detaching The Scanner Wires - Kyocera Mita KM-4530 Service Manual

2BC/D

(2) Detaching and refitting the scanner wires

Follow the procedure below when the scanner wires are broken or to be replaced.
Caution
After replacing the scanner wire, make a test copy and check the copy image. If the image is incorrect, perform the
adjustments (see pages 1-6-31 to 38).

(2-1) Detaching the scanner wires

Procedure
1. Remove the DF.
2. Remove the contact glass.
3. Remove the four screws holding the upper
rear cover and then the cover.
4. Remove the two screws holding the upper left
cover and then the cover.
1-6-22
Figure 1-6-40
Upper rear cover
Figure 1-6-41
DF
Upper left cover