Drawers 1 And 2 Paper Feed - Kyocera Mita KM-4530 Service Manual

2-1-1 Paper feed section
The paper feed system of this copier includes drawers 1 and 2 that hold 500 sheets of paper each, drawer 3 that holds
1,000 sheets, drawer 4 that holds 1,500 sheets, and the bypass table.
The paper feed section consists of the primary paper feed and secondary paper feed subsections. Primary paper feed
conveys paper from one of the four drawers or the bypass table to the upper and lower registration rollers, at which point
secondary paper feed takes place and the paper travels to the transfer/conveying sections in sync with the image printing
timing.

(1) Drawers 1 and 2 paper feed

Drawers 1 and 2 consist of the lift mechanism with the drawer operating plate for making paper come into contact with
the forwarding pulley and the paper feed mechanism with the forwarding pulley for pulling out paper from the drawer, the
upper paper feed pulley and so on.
1 Upper paper feed pulley
2 Lower paper feed pulley
3 Forwarding pulley
4 Upper paper feed housing
5 Lower paper feed housing
6 Paper switch 1 (PSW1)
7 Paper switch 2 (PSW2)
8 Lift limit switch 1 (LILSW1)
9 Lift limit switch 2 (LILSW2)
0 Right feed pulley
! Vertical paper conveying roller B
@ Vertical paper conveying roller C
Figure 2-1-1 Paper feed section (1)
# Left feed guide plate
$ Confluence guide
% Paper feed switch 3 (PFSW3)
^ Paper feed switch 4 (PFSW4)
& Lift operating plate
* Drawer operating plate
( Drawer 1
) Drawer 2
⁄ Upper paper width switch (PWSW-U)
¤ Lower paper width switch (PWSW-L)
‹ Upper paper length switch (PLSW-U)
› Lower paper length switch (PLSW-L)
2BC/D
2-1-1