Other Electrical Components - Kyocera Mita KM-4530 Service Manual

2BC/D

(5) Other electrical components

1
13
12
11
1. Exposure lamp (EL) ...................................... Exposes originals.
2. Cleaning lamp (CL) ...................................... Removes residual charge from the drum surface.
3. Pre-cleaning lamp 1 (PCL1) .........................
4. Pre-cleaning lamp 2 (PCL2) .........................
5. Laser scanner unit (LSU)
• Polygon motor (PM) ................................... Drives the polygon mirror.
• Laser diode (LD) ........................................ Generates the laser beam.
6. Fixing heater M (FH-M) ................................ Heats the heat roller.
7. Fixing heater S (FH-S) ................................. Heats the heat roller.
8. Fixing unit thermostat (FTS) ......................... Prevents overheating in the fixing section.
9. Fixing unit thermistor (FTH) ......................... Detects the heat roller temperature.
10. Hard disk drive (HDD) .................................. Enables printing, special purpose copying and Box management
11. Power relay (PRY) ........................................ Turns the AC power and 24 V DC power supplies to the fixing section on
12. Total counter (TC) ......................................... Displays the total number of copies produced.
13. Scanner dehumidify heater (SH)* ................ Dehumidifies the scanner unit.
14. Dehumidify heater (DH1) ............................. Dehumidifies the drawer 1 and 2 section.
15. Dehumidify heater (DH2) ............................. Dehumidifies the drawer 3 section.
16. Dehumidify heater (DH3) ............................. Dehumidifies the drawer 4 section.
*: Option
2-2-6
5
2
7 6
9
3,4
8
10
14
15
16
Figure 2-2-5 Other electrical components
function.
and off.
Machine front
Machine inside
Machine rear