Detaching And Refitting The Bypass Forwarding, Upper And Lower Paper Feed Pulleys - Kyocera Mita KM-4530 Service Manual

2BC/D

(2) Detaching and refitting the bypass forwarding, upper and lower paper feed pulleys

Follow the procedure below to clean or replace the bypass forwarding, upper and lower paper feed pulleys.
Procedure
• Removing the bypass paper feed unit
1. Remove the developing duct cover and
middle right cover (see page 1-6-3).
2. Raise the bypass tray in the direction of the
arrow and lift it.
3. Disconnect the connectors of the bypass tray
and then remove the tray.
4. Remove the five screws holding the bypass
paper feed unit and disconnect the connecter,
and then the unit.
• Removing the bypass forwarding pulley
5. Remove the stop ring form the bypass
forwarding pulley retainer.
6. Pull the bypass forwarding pulley shaft in the
direction of the arrow, and then remove the
bypass forwarding pulley.
1-6-10
Bypass tray
Screws
Bypass paper feed unit
Connector
Figure 1-6-20
Figure 1-6-21
Bypass forwarding pulley
Bypass forwarding pulley shaft
Stop ring
Figure 1-6-22
Connector
Screws