Adjusting The Margins For Scanning An Original On The Contact Glass - Kyocera Mita KM-4530 Service Manual

2BC/D-1

(11) Adjusting the margins for scanning an original on the contact glass

Perform the following adjustment if the margins are not correct.
U402
U403
(P. 1-6-18)
Caution
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Start
Enter maintenance mode.
Enter "403" using the numeric keys.
Press the start key.
Select the item to be adjusted.
Press the interrupt key.
Press the start key
to make a test copy.
Are the margins correct?
Yes
Proceed to another mode?
Press the stop/clear key to
exit maintenance mode.
1-6-38
U404
(P. 1-6-72)
A MARGIN: Scanner left margin
B MARGIN: Scanner leading edge margin
C MARGIN: Scanner right margin
D MARGIN: Scanner trailing edge margin
Change the setting.
No
Yes
Setting range (initial setting)
No
Changing the value by one moves
the margin by 0.1 mm for all.
End
Press the start key.
The new setting
is stored.
Increasing the value using the cursor
up key makes the margin wider.
Decreasing the value using the
cursor down key makes the margin
narrower.
Scanner left margin: 0 – +10.0 (2.0)
Scanner leading edge margin: 0 – +10.0 (2.0)
Scanner right margin: 0 – +10.0 (2.0)
Scanner trailing edge margin: 0 – +10.0 (4.0)
Scanner leading edge margin
Ejection direction
(reference)
Scanner
left margin
(2 ± 1.0 mm)
Figure 1-6-70
(3 ± 1.5 mm)
Scanner
right margin
(2 ± 1.0 mm)
Scanner trailing edge margin
(2 ± 1.0 mm)