Kyocera Mita KM-4530 Service Manual page 60

2BC/D
Installing the Optional Bar-Code Reader
7. Fasten the serial connector in place with two
screws.
Installing the Optional Memory DIMM
8. Remove the printing system, and insert the
optional memory DIMM firmly into either of
the memory slots. Push the DIMM firmly into
the slot so that the two hooks (one hook at
each end of the slot) snap closed.
• The board provides two DIMM slots, and
can accept up to two optional DIMMs. If
installing a single DIMM, you can use either
slot.
1-3-32
Figure 1-3-68
Optional memory DIMM
Two hooks Memory slots
Figure 1-3-69
Serial connector
Two hooks