Kyocera Mita KM-4530 Service Manual page 340

Connector Pin No.
1 S.G(3.4V)
CN6
2 S.G
Connected
3 S.G
to the main
4 S.G
PCB, DF
5 G(5V)
driver PCB,
6 S.G
Tandem
7 G(5V)
printer
8 S.G
PCB*,
9 S.G
engine
10 S.G
PCB, and
11 G(5V)
side deck*.
1 12V
CN7
2 S.G(12V)
Connected
3 5V
to the hard
4 S.G
disk drive.
CN8 1 LIVE OUT
Connected
3 -
to the main
switch.
5 LIVE IN
1 NEUTRAL OUT
CN9
Connected
2 -
to the
power relay.
CN10 1 -
Connected
2 -
to the fixing
heater M
and fixing
heater S.
CN11 1 24V
2 P.G
Connected
to the
power
source fan
motor.
CN12 1 -
Connected
4 -
to the
dehumiditify
heaters.
*: Optional
Signal I/O Voltage
- Ground
- Ground
- Ground
- Ground
- Ground
- Ground
- Ground
- Ground
- Ground
- Ground
- Ground
O 12 V DC
- Ground
O 5.2 V DC
- Ground
O 120 V AC or
220-240 V AC
I 120 V AC or
220-240 V AC
I 120 V AC or
220-240 V AC
O 120 V AC or
220-240 V AC
I 120 V AC or
220-240 V AC
O 120 V/0 V AC or
220-240 V/0 V AC
O 120 V/0 V AC or
220-240 V/0 V AC
O 24 V DC
- Ground
O 120 V/0 V AC or
220-240 V/0 V AC
O 120 V AC
220-240 V AC
Description
Ground for MPCB
Ground for DFDPCB
Ground for side deck*
Ground for SDPCB
Ground for MPCB
Ground for TAMPCB*
Ground for EPCB
Ground for MPCB
Ground for MPCB
Ground for MPCB
Ground for MPCB
Power supply for HDD
Ground for HDD
Power supply for HDD
Ground for HDD
AC power source to MSW
AC power source via MSW
AC power source via MSW
AC power source to PRY
AC power source via PRY
FH-M: On/Off
FH-S: On/Off
Power supply for PSFM
Ground for PSFM
DH1*, DH2*, and DH3*: On/Off
AC power source for DH1*, DH2*, and DH3*
2BC/D
2-3-5