Kyocera Mita KM-4530 Service Manual page 110

Maintenance
item No.
U206 Setting the presence or absence of the coin vender
Description
Sets the presence or absence of the optional coin vender. Also sets the details for coin vender operation, such
as mode and unit price.
This is an optional device which is currently supported only by Japanese specification machines, so no setting
is necessary.
U207 Checking the operation panel keys
Description
Checks operation of the operation panel keys.
Purpose
To check operation of all the keys and LEDs on the operation panel.
Method
1. Press the start key. The screen for executing is displayed.
2. "COUNT1" is displayed and the leftmost LED on the operation panel lights.
3. As the keys lined up in the same line as the lit indicator are pressed in the order from the top to the bottom,
the figure shown on the touch panel increases in increments of 1. When all the keys in that line are pressed
and if there are any LEDs corresponding to the keys in the line on the immediate right, the top LED in that
line will light.
4. When all the keys on the operation panel have been pressed, all the LEDs light for up to 10 seconds.
5. When the LEDs go off, press the start key. All the LEDs light for 10 seconds again.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
U208 Setting the paper size for the large paper deck
Description
Sets the sizes of paper placed in drawer 3, drawer 4 and optional side deck (55 cpm copier only) respectively.
Purpose
To set the size when the size of paper placed in drawer 3, drawer 4 or optional side deck is changed.
Method
Press the start key. The screen for selecting an item is displayed.
Setting
1. Select the paper size (A4/11" × 8
Initial setting: A4/11" × 8
2. Press the start key. The setting is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Description
1
/ " or B5). The selected item is displayed in reverse.
2
1
/ "
2
2BC/D
1-4-43