Kyocera Mita KM-4530 Service Manual page 257

(4) Detaching and refitting the cleaning brush, front and rear cleaning seal and bushing brush
Follow the procedure below to replace the cleaning brush, front and rear cleaning seal and bushing brush.
Procedure
1. Remove the cleaning unit (see page 1-6-50).
2. Remove the cleaning lower seal and cleaning
blade (see pages 1-6-50 and 52).
3. Remove the front and the rear cleaning seals
from the cleaning housing.
4. Remove the bushing sponge from the front of
the cleaning housing.
5. Remove an E ring, a gear, and a bushing
from the front and the rear of the cleaning
brush respectively.
6. Remove the cleaning brush from the cleaning
housing.
Bushing sponge
Front cleaning seal
Gear
Bushing
E ring
Cleaning brush
Rear cleaning seal
Figure 1-6-97
E ring
Bushing
Figure 1-6-98
Figure 1-6-99
2BC/D
Gear
1-6-53