Adjusting The Amount Of Slack In The Paper At The Vertical Conveying - Kyocera Mita KM-4530 Service Manual

2BC/D-1

(6-6) Adjusting the amount of slack in the paper at the vertical conveying

Make the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
Procedure
Start
Enter maintenance mode.
Enter "054" using the numeric keys.
Press the start key.
Select the item to be adjusted.
Press the interrupt key.
Press the start key
to make a test copy.
Is the leading
edge of the image missing
or varying randomly (copy
example 1)?
Is the copy
paper Z-folded (copy
example 2)?
Press the stop/clear key to
exit maintenance mode.
1-6-20
• Amount of slack in the paper of the vertical conveying
DUP LOOP ADJ : Duplex paper feeding (second face) of
A3, A5, 11" 17", and 5
DUP LOOP ADJ2 : Duplex paper feeding (second face) of
B4, A4, B5, 8
BYP LOOP ADJ : Paper feeding through the bypass
Yes
Increase the value using the cursor up key.
No
Yes
Decrease the value using the cursor down key.
Setting range (initial setting)
No
Changing the value by 1 moves the amount of slack by 1.0 mm.
The greater the value,
the larger the amount of slack;
the smaller the value, the smaller
the amount of slack.
End
Original
example 1
Figure 1-6-37
× ×
1 1
/ " 8 /
2 2
× ×
1
/ " 14", and 11" 8
2
Press the start key.
The new setting is stored.
DUP LOOP ADJ : 0 – +200 (70)
DUP LOOP ADJ2 : 0 – +200 (70)
BYP LOOP ADJ : 0 – +200 (0)
Copy Copy
example 2
" sizes
1
/ " sizes
2