Kyocera Mita KM-4530 Service Manual page 55

15. Open the right cover. Attach the retaining rail
to the copier with the V-groove of the rail
aligned with the center of the scale located at
the base of the copier, using the two M4 × 6
TP-A chromate screws.
16. When the side deck is installed on the copier,
connect the deck signal cable to the
connector on the copier rear.
Center
Scale
V-groove
M4 × 6 TP-A chromate screws
Figure 1-3-57
Retaining rail
Connector
Deck signal cable
Figure 1-3-58
2BC/D
1-3-27