Kyocera Mita KM-4530 Service Manual page 63

11. Secure the interface mounting plate with the
two screws removed in step 5.
12. Secure the connector of the interface PCB to
the interface mounting plate with two M2.6 ×
5 brass binding screws.
13. Refit the upper and lower sequence covers,
the lower rear cover, the middle rear cover,
and the middle rear C cover.
14. Connect the interface cable to the connector
of the interface PCB.
Interface mounting plate
M2.6 × 5 brass
binding screws
Figure 1-3-76
Interface cable
Figure 1-3-77
2BC/D
Screws
1-3-35