Kyocera Mita KM-4530 Service Manual page 203

2BC/D
Problem
(7)
Paper jams.
(8)
Toner drops on the pa-
per conveying path.
(9)
Abnormal noise is
heard.
1-5-56
Causes/check procedures
Check if the press roller is extremely dirty or
deformed.
Check if the contact between the heat roller
and its separation claws is correct.
Check if the contact between the eject roller
and pulley is correct.
The feedshift solenoid malfunctions.
Check if the contact between the feedshift
lower roller and feedshift pulley is correct.
Check if the developing unit is extremely
dirty.
Check if the pulleys, rollers and gears oper-
ate smoothly.
Check if the following electromagnetic
clutches are installed correctly: paper feed
clutches 1/2/3/4, feed low clutches 1/2, feed
high clutches 1/2, feed clutches 3/4/5, deck
feed clutch and bypass paper feed clutch.
Corrective measures
Clean or replace the press roller.
Repair if any springs are off the separation
claws.
Check visually and remedy if necessary.
See page 1-5-47.
Check visually and remedy if necessary.
Clean the developing unit.
Grease the bearings and gears.
Correct.