Kyocera Mita KM-4530 Service Manual page 279

( 5-2 ) Adjusting the DF trailing edge registration
Procedure
Enter maintenance mode.
Enter "071" using the numeric keys.
Press the start key.
Select "TRAIL EDGE ADJ".
Press the interrupt key.
Place an original on the DF
and make a test copy.
Is the image correct?
Press the stop/clear key to
exit maintenance mode.
Start
For copy example 1, increase
No
the value using the cursor up key.
For copy example 2, decrease
the value using the cursor down key.
Yes
Setting range: –32 – +32
initial setting: –15
Changing the value by 1 moves
the trailing edge by 0.19 mm.
Increasing backward and decreasing it moves
the image forward.
End
Original Copy
example 1
Figure 1-6-128
Press the start key.
The new setting
is stored.
2BC/D-1
Copy
example 2
1-6-71 1-6-75