Printing Option Network Status Page - Kyocera Mita Ecosys FS-6020 Operation Manual

Chapter 1 Using the Operator Panel

Printing Option Network Status Page

NOTE
To use this function, the network interface card must be installed
on the printer.
You can print out a status page for the option network inter-
face. The option network status page shows the firmware ver-
sion, the network addresses, and other information under
various network protocols about the network interface. The
default setting is Off (print disabled). When On (print) is se-
lected, the option network status page will be output after the
printer status page.
NOTE
Printing out a network interface status page may not be possible
with some optional network interface cards. For details, see the
manual for the network interface.
1
Press the MENU key.
2 Press the or
> appears.
Interface
Parallel
3 Press the ENTER key. A blinking question mark (?)
appears.
Interface
? Parallel
4 Press the or
pears.
Interface
? Option
5
Press the ENTER key again. The question mark (?)
disappears.
Interface
Option
6 Press the key and then press the
peatedly until the message display indicates
>Opt. StatusPage.
>Opt. StatusPage
Off
1-12
key repeatedly until Interface
>
key repeatedly until Option ap-
>
or
7 The default setting is Off. Change it as follows.
Press the ENTER key. A blinking question mark (?)
appears.
>Opt. StatusPage
? Off
8 Select On using the
>Opt. StatusPage
? On
9 Press the ENTER key again.
>Opt. StatusPage
10 Press the MENU key. The message display returns to
Ready.
key re-
or key.
On
NETWORK STATUS PAGE
Network Status Page
Page 1 of 4