Kyocera Mita KM-4530 Service Manual page 185

2BC/D-1
(22) There is a regular
error between the
leading edges of
the original and
copy image when
the DF is used.
Causes
1. Misadjusted DF original scanning start
position.
(23) There is a regular
error between the
trailing edges of the
original and copy
image when the DF
is used.
Causes
1. Misadjusted DF original scanning end
position.
(24) When the duplex
unit is used, the
center of the
original image and
that of the copy
image do not align.
Causes
1. Side registration section installed incorrectly.
1-5-40
Causes
1. Misadjusted DF original scanning start
position.
Readjust the DF original scanning start position (see page 1-6-70).
Causes
1. Misadjusted DF original scanning end
position.
Readjust the DF original scanning end position (see page 1-6-71).
Causes
1. Side registration section installed incorrectly.
Adjust the installation position of the side registration section.
Check procedures/corrective measures
Check procedures/corrective measures
Check procedures/corrective measures