Kyocera Mita KM-4530 Service Manual page 84

Maintenance
item No.
U035 Setting folio size
Description
Changes the image area for copying onto folio size paper.
Purpose
To prevent the image at the trailing edge, or right or left side of the paper from not being copied by setting the
actual size of the folio paper used.
Method
Press the start key. The screen for adjustment is displayed.
Setting
1. Select the item to be set. The selected item is displayed in reverse.
2. Change the setting using the cursor up/down keys.
Display
LENGTH DATA
WIDTH DATA
3. Press the start key. The value is set.
Completion
Press the stop/clear key at the screen for adjustment. The screen for selecting a maintenance item No. is
displayed.
U037 Checking fan motor operation
Description
Applies power to each fan motor to turn on.
Purpose
To check the operation of each fan motor.
Method
1. Press the start key. The screen for selecting an item is displayed.
2. Select the desired fan motor to operate. The selected item is displayed in reverse and the operation starts.
Display
CONV FAN
DEV FAN
3. To stop operation, press the stop/clear key.
Completion
Press the stop key after operation stops. The screen for selecting a maintenance item No. is displayed.
U050 Setting the switchback drive
Adjustment
See page 1-6-66.
U051 Adjusting the amount of slack in the paper
Adjustment
See page 1-6-19.
Description
Setting Setting range
Length 330 to 356 mm
Width 200 to 220 mm
Switches
Paper conveying fan motor (PCFM)
Image formation fan motor (IFFM)
2BC/D
Initial setting
330
210
1-4-19