Kyocera Mita KM-4530 Service Manual page 117

2BC/D-1
Maintenance
item No.
U248 Setting the paper eject devices
Descrioption
Adjusts the amount of slack in the paper for finisher punch mode, the booklet stapling position, and the center
folding position for the copier with an optional finisher installed. Also, displays and clears the punch-hole scrap
count.
Purpose
• Adjustment of the amount of slack in the paper in punch mode
Adjusts the amount of slack in the paper while in the punch section if, in punch mode, paper jams or is Z-
folded frequently due to too much slack in the paper, or, the position of punch holes varies due to too little
slack in the paper.
• Punch-hole scrap count display (clearing)
Used to manually clear the punch-hole scrap count if a message requiring collection of punch-hole scrap is
shown on the touch panel after collection.
• Adjustment of booklet stapling position
Adjusts the booklet stapling position in the stitching mode if the position is not proper.
• Adjustment of center folding position
Adjusts the center folding position in the stitching mode if the position is not proper.
Start
Press the start key. The screen for selecting an item is displayed.
Display
PUNCH TIMING
PUNCH TIMING(TURN)
PUNCH COUNT
SADDLE STAPLE ADJUST
SADDLE ADJUST
SADDLE ADJUST 2
Setting the amount of slack in the paper
1. Select PUNCH TIMING on the screen for selecting an item.
2. Select the paper size to be set.
3. Change the setting using the cursor up/down keys.
Display
B5
A4/11 × 8.5
B5R
A4R/8.5 × 11
B4/8.5 × 14
A3/11 × 17
If the position of punch holes varies, increase the setting to make the amount of slack larger.
If paper jams or is Z-folded frequently, decrease the setting to make the amount of slack smaller.
Changing the value by 1 changes the amount of slack by 1.0 mm.
4. Press the start key. The value is set.
5. To return to the screen for selecting an item, press the stop/clear key.
1-4-50
Description
Operation
Adjustment of the amount of slack in the paper in punch mode
Adjustment of the amount of slack in the paper at reversed
paper ejection in punch mode
Punch-hole scrap count display
Booklet stapling position adjustment
Adjustment of center folding position
Adjustment of center folding position (correction of number of
sheets of a batch)
Description
Amount of slack in the paper of B5 size
Amount of slack in the paper of
A4/11" × 8
1
/ " size
2
Amount of slack in the paper of B5R size -15 to +15
Amount of slack in the paper of
" × 11" size
1
A4R/8 /
2
Amount of slack in the paper of
" × 14" size
1
B4/8 /
2
Amount of slack in the paper of
A3/11" × 17" size
Setting range Initial setting
-15 to +15 0
-15 to +15 0
0
-15 to +15 0
-15 to +15 0
-15 to +15 0