Kyocera Mita KM-4530 Service Manual page 260

2BC/D
3. Remove the screw on the front of fixing unit.
4. Disconnect the two connectors on the rear of
fixing unit and remove the screw holding the
heater retainer and then the retainer.
5. Pull out the fixing heater M and S from the
rear of fixing unit.
6. Replace the fixing heater M and S and all the
removed parts.
* When replacing the fixing heater M and S
alone, remove the screw from the junction
portion.
* When fitting the fixing heater M and S,
connect the connectors to those with the
corresponding colors respectively.
1-6-56
Screw
Figure 1-6-103
Connectors
Figure 1-6-104
Figure 1-6-105
Screw
Heater retainer
Fixing heater M and S