Kyocera Mita KM-4530 Service Manual page 278

2BC/D-1
( 5 ) Adjusting the scanning start position when the DF is used
Perform the following adjustment if there is a regular error between the leading or trailing edges of the original and the
copy image.
U034 U066
(P. 1-6-15) (P. 1-6-37)
Caution
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
( 5-1 ) Adjusting the DF leading edge registration
Procedure
Enter maintenance mode.
Enter "071" using the numeric keys.
Press the start key.
Select "LEAD EDGE ADJ".
Press the interrupt key.
Place an original on the DF
and make a test copy.
Is the image correct?
Press the stop/clear key to
exit maintenance mode.
1-6-74 1-6-70
U071
Start
For copy example 1, increase
No
the value using the cursor up key.
For copy example 2, decrease
the value using the cursor down key.
Yes
Setting range: –32 – +32
initial setting: 10
Changing the value by 1 moves
the leading edge by 0.19 mm.
Increasing backward and decreasing it moves
the image forward.
End
Original Copy
example 1
Figure 1-6-127
Press the start key.
The new setting
is stored.
Copy
example 2