Kyocera Mita KM-4530 Service Manual page 249

5. Disconnect the two connectors.
6. Raise the shutter a little and slide it toward
the front side of the machine.
7. Turn the sub toner hopper to the right of the
machine.
8. Remove the developing unit from the image
formation unit.
9. Check, clean or replace the developing unit
and refit all the removed parts.
* When refitting the image formation unit, be
sure to reconnect the connector.
Connector
Connector
Shutter
Figure 1-6-81
Figure 1-6-82
2BC/D-1
Sub toner hopper
Developing unit
1-6-45