Kyocera Mita KM-4530 Service Manual page 183

2BC/D-1
(15) Image is partly miss-
ing.
Causes
1. Paper damp.
2. Paper creased.
3. Drum condensation.
4. Flawed drum.
(16) Fixing is poor.
Causes
1. Wrong paper.
2. Defective pressure springs.
3. Flawed press roller.
4. Proper paper type is not set.
(17) Image is out of fo-
cus.
Causes
1. Defective image scanning unit.
(18) Image center does not
align with the original
center.
Causes
1. Misadjusted image center line.
2. Misadjusted scanner center line.
3. Original placed incorrectly.
1-5-38
Causes
1. Paper damp.
2. Paper creased.
3. Drum condensation.
4. Flawed drum.
Check the paper storage conditions.
Replace the paper.
Clean the drum.
Replace the drum (see page 1-6-42).
Causes
1. Wrong paper.
2. Defective pressure springs.
3. Flawed press roller.
4. Proper paper type is not set.
Check if the paper meets specifications.
Replace the pressure springs.
Replace the press roller (see page 1-6-59).
Set the paper type. (Refer to page 1-4-6.)
Causes
1. Defective image scanning unit.
Replace the image scanning unit (see page 1-6-30).
Causes
1. Misadjusted image center line.
2. Misadjusted scanner center line.
3. Original placed incorrectly.
Readjust the image center line (see page 1-6-17).
Readjust the scanner center line (see page 1-6-37).
Place the original correctly.
Check procedures/corrective measures
Check procedures/corrective measures
Check procedures/corrective measures
Check procedures/corrective measures