Kyocera Mita KM-4530 Service Manual page 48

2BC/D
7. Join the finisher and the copier by hanging
the hooks onto the fittings inside the copier.
8. Join the finisher and the copier so that the
long pin of the finisher connecting plate is
inserted into the hole at the rear of the
finisher and the two short pins into the holes
on the connecting rail.
Finisher
9. Make sure that the finisher is securely joined
with the copier. Then, push the connecting rail
in and lock back down with the screw.
1-3-20
Hooks
Fittings
Connecting rail
Long pin
Short pins
Figure 1-3-39
Figure 1-3-40
Hole
Holes
Finisher connecting plate
Connecting rail