Kyocera Mita KM-4530 Service Manual page 254

2BC/D
1-6-8 Cleaning section
(1) Detaching and refitting the drum separation claw and cleaning lower seal
Follow the procedure below to replace the drum separation claw and cleaning lower seal.
Procedure
1. Remove the drum (see page 1-6-42).
2. Remove the four screws and disconnect the
connector of the cleaning earth wire, and then
remove the cleaning unit.
3. Remove the two screws holding each of the
drum separation claw units and then the
units.
4. Remove the pulley, spring and drum
separation claw from the drum separation
claw unit.
1-6-50
Cleaning earth wire
Figure 1-6-90
Drum separation claw units
Figure 1-6-91
Spring
Drum separation claw
Figure 1-6-92
Cleaning unit
pulley