Adjusting The Center Line Of Image Printing - Kyocera Mita KM-4530 Service Manual

(6-3) Adjusting the center line of image printing

Make the following adjustment if there is a regular error between the center lines of the copy image and original when
paper is fed from the drawer.
U067
U034
(P. 1-6-37)
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the above adjustments in maintenance
mode.
Procedure
Enter maintenance mode.
Enter "034" using the numeric keys.
Press the start key.
Select the item to be adjusted.
Press the interrupt key.
Press the start key to output a test
pattern.
Is the image correct?
Press the stop/clear key to exit
maintenance mode.
U072
(P. 1-6-69)
Start
LSU OUT: Center line adjustment data
LSU OUT (DUP): Center line adjustment data for
For output example 1, decrease
No
the value using the cursor down key.
For output example 2, increase
the value using the cursor up key.
Yes
Setting range (initial setting)
LSU OUT: –5.0 – +5.0 (–2.8)
LSU OUT (DUP): –2.0 – +2.0 (0)
Changing the value by 1 moves the
center line by 0.1 mm.
End
Center line of printing
Correct image Output
example 1
Figure 1-6-34
duplex copying (second face)
Press the start key.
The new setting is stored.
2BC/D-1
Output
example 2
1-6-17