Installing The Network Interface Card - Kyocera Mita Ecosys FS-1010 Service Manual

(7) Installing the network interface card

If the serial interface board kit is installed, remove it to use the network interface card.
CAUTION Take precautions that no foreign substances such as metal chips or liquid get
inside the printer during the installation process. Operation of the printer during
the presence of a foreign substance may lead to fire or electric shock.
WARNING Turn the printer's power switch off. Unplug the printer's power cable and
disconnect the printer from the computer or the network. Never insert or
remove a network interface card while the printer power is ON.
Remove the two screws 1 from the option interface slot cover 2 and remove the option interface
slot cover ( or the serial Interface board) .Insert the network interface card 3 in the slot. Insert as
shown in the figure. Push it in all the way. Secure the network interface card by using two screws
1.
2
FS-1010
1
Figure 2-2-11 installing the memory card
3
2-14
1