Adjusting The Amount Of Slack In The Paper At The Registration Roller - Kyocera Mita KM-4530 Service Manual

(6-5) Adjusting the amount of slack in the paper at the registration roller

Make the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
Procedure
Start
Enter maintenance mode.
Enter "051" using the numeric keys.
Press the start key.
Select the item to be adjusted.
Press the interrupt key.
Press the start key
to make a test copy.
Is the leading
edge of the image missing
or varying randomly (copy
example 1)?
Is the copy
paper Z-folded (copy
example 2)?
Press the stop/clear key to
exit maintenance mode.
• Amount of slack in the paper at the registration roller
DECK DATA : Drawer 1
DECK DATA2 : Drawer 2
BYPASS DATA : Bypass tray
DUPLEX DATA : Duplex copying (second face)
Yes
No
Yes
Decrease the value using the cursor down key.
Setting range (initial setting)
No
Changing the value by 1 moves the amount of slack by 1.0 mm.
The greater the value, the larger the amount of slack;
the smaller the value, the smaller the amount of slack.
End
Original
Figure 1-6-36
Press the start key.
The new setting is stored.
Increase the value using the cursor up key.
DECK DATA : –30 – +40 (–10)
DECK DATA2 : –30 – +40 (3)
BYPASS DATA : –30 – +40 (25)
DUPLEX DATA : –30 – +40 (18)
Copy Copy
example 1 example 2
2BC/D-1
1-6-19