Kyocera Mita KM-4530 Service Manual page 280

2BC/D-1
( 6 ) Adjusting the margins for scanning the original from the DF
Perform the following adjustment if margins are not correct.
U402
U403
(P. 1-6-18) (P. 1-6-38)
Caution
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Enter "404" using the numeric keys.
Press the start key.
Select the item to be adjusted.
Press the interrupt key.
Place an original on the DF
and make a test copy.
Are the margins correct?
Yes
Proceed to another mode?
Press the stop/clear key to
exit maintenance mode.
1-6-72 1-6-76
U404
Start
A MARGIN: DF left margin
B MARGIN: DF leading edge margin
C MARGIN: DF right margin
D MARGIN: DF trailing edge margin
No
Yes
Setting range (initial setting)
Changing the value by one moves
No
the margin by 0.1 mm for all.
End
Ejection direction
(reference)
Press the start key.
The new setting
is stored.
Change the setting.
Increasing the value using the cursor
up key makes the margin wider.
Decreasing the value using the
cursor down key makes the margin
narrower.
DF left margin: 0 – +10.0 (1.5)
DF leading edge margin: 0 – +10.0 (3.0)
DF right margin: 0 – +10.0 (2.0)
DF trailing edge margin: 0 – +10.0 (4.0)
DF left margin
+1.5
(2.5 mm)
–2.0
Figure 1-6-129
DF leading edge margin (3 ± 2.5 mm)
DF right margin
+1.5
(2.5
–2.0
DF trailing edge margin
(3 ± 2.5 mm)
mm)