Kyocera Mita KM-4530 Service Manual page 210

2BC/D
11. Remove the two stop rings and disconnect
the connecter of the paper feed clutch.
12. Pull the upper paper feed shaft in the
direction of the arrow, and then remove the
upper paper feed pulley.
* When fitting the upper paper feed pulley, put
the end face with a silver ring to the front side
of the machine.
* When fitting the upper paper feed shaft,
ensure that the notch of the paper feed clutch
is inserted into the detent.
• Removing the lower paper feed pulley
13. Remove the stop ring on the rear of the
primary paper feed unit.
14. Pull the lower paper feed shaft in the direction
of the arrow, and then remove the lower
paper feed pulley.
15. Refit all the removed parts.
1-6-6
Upper paper feed pulley
Upper paper feed shaft
Stop rings
Figure 1-6-10
Lower paper feed shaft
Lower paper feed pulley
Figure 1-6-11
Connector
Stop ring