Auto: When the pattern limit is released, the remainder of the transition is
Manual: After the pattern limit is released, the transition waits for the next
Setting the default wipe edge softness
1
2
Setting the mode in which all signals can be selected for input to
the color corrector
Press [CCR Internal Signal Enable] in the Switcher > Key/Wipe/FM/CCR
menu, turning it on.
You can select signals generated internally to the switcher as material for input
to the color corrector.
Note
When you select an M/E reentry signal as material for input to the color
corrector, 1H delay occurs to the output signal of M/E.
Settings Relating to Function Links (Link Menu)
Carry out setup relating to links by displaying the Switcher >Link menu.
To display the Link menu
In the Engineering Setup menu, select VF3 'Switcher' and HF6 'Link.'
The status area shows the current link information.
Setting a cross-point button link
To link together two buses internal to the switcher, use the following
procedure.
1
410
Setup Relating to Switcher Processor
carried out automatically at a special-purpose transition rate.
operation, then executes. Until you move the fader lever or press [AUTO
TRANS], the transition is not executed.
In the Switcher >Key/Wipe/FM/CCR menu, press [Wipe Edge Default],
turning it on.
Set the following parameter.
Knob
Parameter
Adjustment
3
Soft
Default value of wipe edge
softness
In the Switcher >Link menu, press [Internal Bus Link].
Setting values
–
50.00 to +50.00