Creating And Editing A Macro - Sony MVS-8000 User Manual

Executing a macro in step execution mode
After recalling the macro register, to execute a macro in step execution mode,
use the following procedure.
Note
To execute a macro in step execution mode requires setting the step execution
mode in the Setup menu.
For details of the method of setting, see "Setting the macro execution mode"
(page 380).
1
In the simple type Flexi Pad control block, press the [MCRO] button,
turning it on.
This assigns the Flexi Pad control block to macro operation.
2
Press the button in the memory recall section showing the register to be
recalled.
3
Press the [Take] button.
This executes one event within the macro, then stops.
The number of events executed, as shown in the memory recall section
status display, is incremented by one.
4
Repeat step 3, executing the macro event by event.
When all events in the macro have been executed, the [Take] button goes
off.

Creating and Editing a Macro

Creating a macro
1
In the simple type Flexi Pad control block, press the [MCRO] button,
turning it on.
This assigns the Flexi Pad control block to macro operation.
2
While holding down the [MCRO] button in the Flexi Pad control block,
press the button in the memory recall section showing the desired register
name.
This assigns the Flexi Pad control block to macro editing.
Macro Operations in the Simple Type Flexi Pad Control Block
513