Replacing Switch Label; Installing The Menu Panel - Sony ICP-X7000 Installation Manual

1-9. Replacing Switch Label

Replace the switch label according to the system configu-
ration in combination with ICP-X7000 and setup settings.
Contact your local Sony Sales Office/Service Center about
label types and other information.
1. Remove the cap/diffusion plate according to "1-7.
Removing and Installing Cap/Diffusion Plate."
2. Insert one end of the Cap pull tool into one groove of
the removed cap/diffusion plate, and then push the end
of the Cap pull tool against the wall in front of the
other groove.
3. In this state, push the end of the Cap pull tool in the
direction of arrow A and draw the diffusion plate in the
direction of arrow B to remove it.
Groove of the
diffusion plate
A
Groove of the
diffusion plate
Cap
4. Remove the current label and install the new label to
the cap.
5. Install the diffusion plate.
6. Install the cap/diffusion plate at the previous position.
ICP-X7000
Cap pull tool
A
B
Wall of the
diffusion plate
Cap
Wall of the
diffusion plate
(Red part)

1-10. Installing the Menu Panel

The menu panel (MKS-X7011) can be installed to the
monitor arm (mounting dimensions below) conforming to
the VESA standard by using the adaptor supplied with ICP-
X7000.
Dimensional drawing of the adaptor mounting
part (conforming to the VESA standard)
75 mm
4-M4
The following parts supplied with ICP-X7000 are required
to install the menu panel.
n
Use the following specified accessories to install the menu
panel.
. Adaptor
. Screw B3 x 5 (4 pcs)
. Screw B4 x 8 (4 pcs)
. AC adaptor (as needed)
4-M4
100 mm
1-25 (E)