Softening the border edges
Press [Border Soft], turning it on, and set the following parameters.
Knob
1
Crop Settings
This effect crops the image.
For an illustrative figure and other information, see "DME Special Effects" in
Chapter 1 (Volume 1).
Cropping the image
1
2
3
28
DME Special Effect Operations
Parameter
Adjustment
Soft
Softness of inner side of border
In the DME menu, select VF1 'Edge' and HF1 'Border/Crop.'
The Border/Crop menu appears.
Press [Crop], turning it on.
The Crop effect is enabled. You can adjust degree of cropping with the
knobs.
Set the parameters.
The valid ranges of the parameter values depend on the combination of
signal format (SD/HD) and aspect ratio (4:3/16:9) selected in the system,
as follows.
• SD format, 4:3 mode
Knob
Parameter
1
H
2
V
3
All
Knob
Parameter
1
Top
2
Left
Parameter group [1/2]
Adjustment
Crop positions on left and right
sides
Crop positions on top and
bottom sides
Crop positions on all sides
Parameter group [2/2]
Adjustment
Crop position on top side
Crop position on left side
Setting values
0.00 to 100.00
Setting values
Left value shown
Top value shown
Left value shown
Setting values
–3.00 to +3.00
–4.00 to +4.00