Sony MVS-8000 User Manual page 369

3
4
5
368
Setup Relating to Operations From the Control Panel
• Turn the knob.
Knob Parameter
1 Port
In the <Trigger Type> group, select the trigger type.
(Rising Edge): Apply the trigger on a rising edge of an input pulse.
(Falling Edge): Apply the trigger on a falling edge of an input
pulse.
(Any Edge): Apply the trigger on a change in the polarity of the
input signal.
(Level): Carry out the specified operation when the input is low or
high.
No Operation: Apply no trigger on an input pulse.
In the <Target> group, select the action block.
M/E-1, M/E-2, M/E-3, P/P: Set the action for one of the banks.
Common/Setup: Set an action for something other than the above, or a
setup action.
Using any of the following methods, select the action to be set.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knobs.
Knob Parameter
2 Action
4 Aux Bus No
5 Reg No
5 Src No
5 No
a) • Action list when the trigger type is other than "Level"
When Target is M/E-1, M/E-2, or M/E-3: Cut, Auto Trans
Key1 Cut, Key2 Cut, Key3 Cut, Key4 Cut
Key1 Auto Trans, Key2 Auto Trans, Key3 Auto Trans, Key4 Auto Trans
Key1 SS ? Recall, Key2 SS ? Recall, Key3 SS ? Recall, Key4 SS ? Recall
Adjustment
Port selection
Adjustment
Action selection
Aux bus selection
Register number
Source signal selection
User preference button
selection
Setting values
1 to 8
Setting values
a)
1 and upwards
e)
1 to 48
b)
1 to 4
c)
1 to 99
d)
1 to 399
e)
1 and upwards
f)
1 to 16