Sony MVS-8000 User Manual page 552

• When using the color corrector on a 3M/E system with a board with
multi-format support
The above restriction 1 applies.
By setting bit 1 of switch S101 on the CA-44 or CA-54 board to the "Off"
position, you can remove this restriction for M/E reentry signals unless they are
overlaid triply or more. Note, however, that this slightly reduces the input
window.
• When using the color corrector on a 3M/E system with an HD dedicated
board
The above restriction 2 applies.
• When not using the color corrector on a 3M/E system with a board with
multi-format support
The above restriction 2 applies.
By setting bit 1 of switch S101 on the CA-44 or CA-54 board to the "Off"
position, you can remove this restriction. Note, however, that this slightly
reduces the input window.
• When using the color corrector on a 4M/E system
The above restriction 1 applies.
• When not using the color corrector on a 4M/E system
The above restriction 2 applies.
Assigning the color corrector input buses to AUX delegation
buttons
There are two inputs for capturing material to the color corrector: the CCR1
bus and the CCR2 bus.
For details of the input assignment operation, see "Auxiliary Bus Control
Block Settings (Aux Assign Menu)" (page 351).
Selecting the color correction input signal
After assigning CCR1 and CCR2 to AUX buses, use the following procedure.
1
In the auxiliary bus control block, press the AUX delegation buttons
assigned to CCR1 (or CCR2).
2
In the cross-point button row, select the signal to which you want to apply
color correction.
551
Preparations