Signal Output Settings (Output Menu) - Sony MVS-8000 User Manual

To make cross-conversion settings
To make the cross-conversion settings, carry out steps 1 and 2 described in
"To make detailed settings for up-conversion" (page 393). No other settings
are required.
To copy format converter input data
1
2
3
4

Signal Output Settings (Output Menu)

For setup relating to signal outputs, use the Switcher >Output menu.
To display the Output menu
In the Engineering Setup menu, select VF3 'Switcher' and HF3 'Output.'
The status area shows the output signal numbers and names, and output signal
phase for the signals output from Output 1 to 48.
Assigning output signals
To assign a signal to output from an output port, use the following procedure.
1
398
Setup Relating to Switcher Processor
In the Switcher >Input >FC Adjust menu, press [Copy].
The Copy/Swap >Copy >Format Converter menu appears.
The status area shows lists of the copy source on the left, and the copy
destination on the right.
Select [Input] in the <Data Select> group.
Using any of the following methods, select the data.
• Press directly on the list.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter Adjustment
1 Left No Select the copy source data
2 Right No Select the copy destination data
3 Num Select the number of items
Press [Copy].
This copies the data.
In the Switcher >Output menu, press [Output Assign].
Setting values
1 and upwards
1 and upwards
1 and upwards