Sony MVS-8000 User Manual page 251

4
5
6
250
Snapshot Operations From the Numeric Keypad Control Block
Note
The regions that can be selected simultaneously are those assigned to the
region selection buttons in the numeric keypad control block. (See
"Assigning a region to a region selection button in the numeric keypad
control block" (page 328).)
The first button pressed lights green as the reference region, and any
subsequently pressed buttons light amber.
Pressing one of the amber-lit buttons, while holding down [SNAPSHOT],
turns the button green to indicate its corresponding region as the new
reference region.
For details of the precedence order for becoming the reference region, see
"Regions and Registers" in Chapter 1 (Volume 1).
The display shows the name of the reference region and the number of the
register previously recalled for that region.
Press the [STORE] button, turning it on.
Enter the desired register number from the numeric keypad.
To find an empty register, instead of entering a number, press the [.]
(period) button. To search for an empty register common to all currently
selectable regions, press the period button again.
Note
If you choose a register which already contains a snapshot, and save a
snapshot, then the existing register contents are overwritten.
The register number appears in the display. If the number is followed by a
letter 'e' or 'E,' this indicates the following.
e: The selected register is empty for the regions selected in step 3.
E: The selected register is empty for all currently selectable regions.
The entered register number appears in the display.
To apply attributes, press the following buttons, turning them on.
Attribute to apply Button
Effect dissolve [+/–/EFF DISS] button
Auto transition [CLR/AUTO TRANS] button
a) TRIM/GPI ENBL] button
GPI output
a) The GPI port that can be set is 1 (fixed).
For details of attributes, see "Snapshots" in Chapter 1 (Volume 1).