Sony MVS-8000 User Manual page 337

The control panel comprises a main base for installing the principal switcher
bank control blocks, and an extension section for extended control blocks. The
independent key transition control block (simple type) can be installed in
either, but the assignable keys differ as follows.
When the independent key transition control block (simple type) is
installed in the main base
Select the keys to be assigned from the following.
• Key1,2 (keys 1 and 2)
• Key3,4 (keys 3 and 4)
• DSK1,2 (downstream keys 1 and 2)
• DSK3,4 (downstream keys 3 and 4)
• N/A (no assignment)
In this case, "Key1,2" and "Key3,4" are the keys of the switcher bank (M/E-1,
M/E-2, M/E-3, PGM/PST) in which the independent key transition control
block is installed and whose assignment is determined by the M/E Assign
menu.
When the independent key transition control block (simple type) is
installed in the extension section
Select the keys to be assigned from the following.
• M/E-1 Key1,2
• M/E-1 Key3,4
• M/E-2 Key1,2
• M/E-2 Key3,4
• M/E-3 Key1,2
• M/E-3 Key3,4
• DSK1,2
• DSK3,4
• Key1,2
• Key3,4
• N/A (no assignment)
To assign a key to the independent key transition control block (simple type),
use the following procedure. Here the example shown is the case in which keys
3 and 4 ("Key3,4") are assigned to the second row switcher bank of the main
base.
1
336
Setup Relating to Operations From the Control Panel
1)
1)
1) In this case, depending on the switcher extension interface port, operations always apply to
the following.
Ext Port 1: M/E-1
Ext Port 2: M/E-2
Ext Port 3: M/E-3
In the Panel >Config menu, press [Compact Key Module Assign].
The Compact Key Module Assign menu appears.