Tally Group Settings (Group Tally Menu); Wiring Settings (Wiring Menu) - Sony MVS-8000 User Manual

Tally Group Settings (Group Tally Menu)

With the S-Bus protocol, tally control is possible for groups 1 to 8, but in this
system you can use either groups 1 to 4 or groups 5 to 8.
You can also select whether or not to transfer the tally information over the S-
Bus.
To select the tally groups, use the Router/Tally >Group Tally menu.
To display the Group Tally menu
In the Engineering Setup menu, select VF6 'Router/Tally' and HF2 'Group
Tally.'
Setting the tally groups
1
2

Wiring Settings (Wiring Menu)

When configuring a system in which the switcher inputs and outputs are
connected to a router, it is necessary to set this connection configuration
(referred to as "wiring") in the S-Bus space.
To make the wiring settings, use the Router/Tally >Wiring menu. The settings
are common to the parallel and serial tallies.
To display the Wiring menu
In the Engineering Setup menu, select VF6 'Router/Tally' and HF3 'Wiring.'
The status area shows the wiring settings.
Making new wiring settings
1
2
454
Setup Relating to Router Interface and Tally
To select a consecutive sequence of groups from each of groups 1 to 4 and
groups 5 to 8, set [All Group Enable] to On in the Group Tally menu.
In the <Tally Group> group, select the desired groups.
In the Router/Tally >Wiring menu, press [New].
The New menu appears.
With a knob or menu operation, set the destination.
When switcher inputs and outputs are connected to the router in a group,
you can specify the start and end destination addresses.