Interfacing With External Devices (Device Interface Menu) - Sony MVS-8000 User Manual

6
In the same way as in step 4, select the key you want to be the link
destination, then press [Key Set].
To release the link setting
Use the same operation as in step 2 to select the link number for which you
want to release the link setting, then press [Clear].
Interfacing With External Devices (Device Interface
Menu)
To carry out setup relating to connections with external devices, display the
Switcher >Device Interface menu.
To display the Device Interface menu
In the Engineering Setup menu, select VF3 'Switcher' and HF7 'Device
Interface.'
Making 9-pin port device interface settings
The description in this section takes the REMOTE3 port as an example. For
other REMOTE ports, carry out the same process as required.
1
In the Switcher >Device Interface menu, press [Remote Assign].
The Remote Assign menu appears.
2
Select the device interface you want to set for the REMOTE3 port from the
<Remote3> group.
Editor A: assign Editor A to the REMOTE3 port.
Editor B: assign Editor B to the REMOTE3 port.
AUX: assign AUX to the REMOTE3 port.
DME1: assign DME1 to the REMOTE3 port.
Note
When REMOTE3 and REMOTE4 are respectively assigned to DME1 and
DME2, you can switch the AUX bus from the DME (DME-3000/7000)
connected to these ports.
At this time, connect the DME input video signals and key signals as follows.
• DME1 video input: AUX1 output
• DME1 key input: AUX2 output
• DME2 video input: AUX4 output
• DME2 key input: AUX5 output
Setup Relating to Switcher Processor
417