Sony MVS-8000 User Manual page 330

Knob Parameter
1 Button Assign Selection to which setting
4
Using any of the following methods, select the region to be assigned.
• Press directly on the list in the lower part of the right side.
• Press the arrow keys to scroll the reverse video cursor in the list in the
lower part of the right side.
• Turn the knob.
Knob Parameter
2 Region
5
Press [Set], to confirm the selection.
This assigns the region to the region selection button in the numeric
keypad control block.
Note
Only regions assigned here can be used for keyframe or snapshot recall.
If an M/E bank is not assigned to a region selection button in the numeric
keypad control block, the M/E Flexi Pad control block cannot be used to recall
a snapshot.
To set the region selection buttons selected when the [ALL] button
is pressed
1
In the Panel >Config >10 Key Region Assign menu, press [All Select] in
the button area, or the [All Select] button indication in the status area,
setting it to On.
The [All Select] button indication in the status area changes to orange, and
the system switches to a mode for assigning region selection buttons to the
[ALL] button. In the factory default state, all buttons appear in reverse
video, and are assigned to the [ALL] button.
2
If you do not want to assign any region selection button to the [ALL]
button, press the corresponding button indication, setting it to Off.
The button you pressed returns to normal display.
Note
Assignment to the [ALL] button is region by region. Changing the assignment
of a region selection button does not change the regions assigned to the [ALL]
button.
Adjustment
applies
Adjustment
Region selection
Setup Relating to Operations From the Control Panel
Setting values
1 to 4
Setting values
1 and upwards
329