Sony MVS-8000 User Manual page 259

snapshot with the Flexi Pad control block of that M/E bank. (See "Assigning a
region to a region selection button in the numeric keypad control block" (page
328)).
As an example, to recall a snapshot on the M/E-1 bank, use the following
procedure.
1
2
3
4
258
Snapshot Operations in the Flexi Pad Control Block
In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button.
This allocates the Flexi Pad control block to snapshot operations. The
numeric display shows the last selected bank number and the register
number last recalled on the bank.
Select the bank for recall.
See step 3 (page 256) in "Saving a snapshot."
To apply temporary attributes, press the following buttons, turning them
on.
Control block Temporary
attribute to apply
Cross-point control A/B bus cross-point
block hold
Key cross-point hold [XPT HOLD] button in the key bus
Key disable
Flexi Pad control Effect dissolve
block
Auto transition
a) When Xpt Hold mode is selected in setup.
b) When Key Disable mode is selected in setup.
For details of the operation mode of the [XPT HOLD] button, see page
409.
For details of temporary attributes and available attributes, see "Snapshot
Attributes" in Chapter 1 (Volume 1).
Notes
• The cross-point hold and key disable settings are maintained until you
next press the [XPT HOLD] button.
• Applying temporary attributes does not affect the contents of the
register.
Press the button in the memory recall section which shows the desired
register name.
Button
[XPT HOLD] button in the
background A/B bus
[XPT HOLD] button in the key bus
[EFF DISS] button
[AUTO TRANS] button
a)
b)